Tile Adhesive Use

The first step: wet construction wall, ground, wall, ground must maintain internal dry wall, ground surface to keep smooth, rugged or rough surface of the cement mortar can be used;

Step second: remove dust, oil stains and other grassroots, otherwise it will affect the degree of tile adhesive bonding;

The third step: adjust the adhesive, water ash ratio is about 1:4, mixing evenly. The adhesive should be used within 5~6 hours (the temperature is relatively high, the light is sufficient to run out in less time);

The fourth step: the binder after smear on the back, to lay the tile press, until the tile tile on the plain, 15 minutes can be corrected by moving the position.